Catalogue Corrosion detection mapping of concrete structures

Equipment for corrosion detection mapping of concrete structures

Ref.: H0389


iCOR™ is a hand-held device that measures several parameters from the surface of concrete and then analyzes them using advanced algorithms embedded in the device. These quick calculations determine the ‘rate of corrosion’ and ‘corrosion potential’ in the reinforcement as well as the ‘resistivity of concrete’ which are the most important factors in evaluating the service life of a concrete structure. It also records the temperature and humidity of the testing environment which can be used for further analysis of remaining service life of structures.


iCOR™ is a unique device for condition assessment of reinforced concrete structures that can be used for:

• Detection of corrosion in reinforced concrete structures

• Measurement of corrosion rate in existing concrete structures

• Measurement of the electrical resistivity of concrete

• Determination of corrosion potential of rebar in concrete

• Assessment of concrete durability on site

• Rehabilitation and repair of concrete structures


• Easy-to-use: no rebar contact is required, requires minimum training

• Fast: measurements within seconds

• Accurate: comparable to laboratory techniques

• Non-destructive: used for existing structures

• Non-subjective: algorithm-based interpretations

• Efficient: detect initial signs of corrosion


Measurement Time: 3 to 30 s

Applied Voltage Range: <30 V

Measurement Accuracy: 1 mV

Sampling Rate: 0.3 s

Input Impedance: >10 M ohm

Temperature Measurement Range: -30 ~ 60 °C

Temperature Measurement Accuracy: ±0.5 °C

Humidity Measurement Range: 0 ~ 100 %

Humidity Measurement Accuracy: ±3%

Communication Protocol: Bluetooth V4.0 LE

Probe Weight: 250 gr

Operating Conditions

Operating temperature: 0 ~ 45 °C

Operating humidity: 10 ~ 95%

Storage temperature: -20 ~ 70°C

Storage humidity: 10 ~ 80%

Dimensions of the Probe: 200 mm x 50 mm (D x H)

shopping cart neuf user inscrire

Quick support

Producción de Equipos Técnicos e Industriales
Producción de Equipos Técnicos e Industriales, S. A.
Carretera de Algete M-106, km. 4,100
28110 Algete - Madrid (España)
Tel.: 91 628 29 40 • Fax: 91 629 00 59